HP A6829A User's Manual And Service Manual page 93

Setting SCSI ID
To set the initiator SCSI ID for an adapter using the SCSI command, use
the following syntax:
SCSI init bus_number slot_number ID_number
where
bus_number
slot_number
ID_num
For example, to set the SCSI ID for an adapter installed on bus 5 slot 2 to
6, issue the following command:
SCSI init 5 2 6
To display the result, issue the following command:
SCSI init 5 2
The output is as follows:
PCI device /5.2 = 6
Chapter 3
Specifies the number of the bus on which the adapter is
installed.
Specifies the number of the slot the adapter is in.
Specifies the adapter's SCSI ID number.
Get other manuals https://www.bkmanuals.com
Troubleshooting
Setting and Confirming SCSI Parameters
79