HP A6829A User's Manual And Service Manual page 59

Step 2. Determine the HBA's path by doing the following:
a. If you are already at the "Main Menu," type in (for "Information
b. At the "Information Menu," type io (to display I/O interface
PCI DEVICE INFORMATION
Description
-----------
.
.
SCSI bus cntlr
SCSI bus cntlr
.
.
Step 3. Display (and optionally change) the HBA's bus width by performing the
following steps:
a. If you are already at the "Main Menu," type ser (for "Service Menu");
b. In the "Service Menu," type the following command:
scsi path width
Chapter 2
Menu"); go to step b.
If you are not at the "Main Menu," type main (to return to the "Main
Menu"), type in (for "Information Menu"), and then go to step b.
information). The output is as follows:
Path Bus
(dec) #
----- ---
0/0/10/0/0 80
0/0/10/0/1 80
In this example, the HBA's path is 0/0/10/0/0 and 0/0/10/0/1
(shown in bold in the listing above, for highlighting purposes). Note
that the last (farthest right) digit is the channel number—0 for
channel A and 1 for channel B.
go to step b.
If you are not at the "Main Menu," type main (to return to the "Main
Menu"), type ser (for "Service Menu"), and then go to step b.
where, path is the HBA's path (from step 1).
Therefore, using the information for channel A of the HBA in the
example in step 1, type the following:
scsi 0/0/10/0/0 width
This displays the HBA's bus width. The output is as follows:
Get other manuals https://www.bkmanuals.com
Installing the A6829A Adapter
Specifying SCSI Parameters
Slot Vendor
# Id
------ ------
2 0x1000
2 0x1000
Device
Id
------
0x0021
0x0021
45