Installing the A6829A Adapter
Specifying SCSI Parameters
Auto Termination
When you configure the A6829A adapter's auto termination parameter,
you specify the adapter's role in the SCSI bus termination, because the
adapter might be a point of termination.
For more information on SCSI bus termination, including a tutorial, you
can visit HP IT Resource Center (ITRC) at http://itrc.hp.com.
Controlling Auto Termination
You can control auto termination in the A6829A adapter (see "Using the
Jumper for Controlling Auto Termination" on page 40) depending upon
the HP-UX system in which the adapter is installed (see Table 2-2 on
page 24).
Summary of Auto Termination Configurations
Table 2-4 summarizes the possible A6829A auto termination
configurations.
Table 2-4
Summary of A6829A Auto Termination Configurations
40
Jumper Position
Open/ON/ON
Open/ON/ON
Open/OFF/ON
Open/OFF/ON
Shorted/ON/ON
Shorted/ON/ON
Shorted/OFF/ON
Shorted/OFF/ON
Get other manuals https://www.bkmanuals.com
Auto Termination
Feature
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
Termination
Applied on
Adapter
Yes
Yes
1
No
1
No
1
No
1
No
1
No
1
No
Chapter 2