Setting Transfer Rates
To set the SCSI transfer rate for an adapter using the SCSI command,
use the following syntax:
SCSI rate bus_number slot_number rate
where
bus_number
slot_number
rate
For example, to set the SCSI transfer rate for an adapter installed on bus
5 slot 2 to Fast SCSI, issue the following command:
SCSI rate 5 2 10
To display the result, isssue the following command:
SCSI rate 5 2
The output is as follows:
PCI device /5.2 = fast SCSI
Chapter 3
Specifies the number of the bus on which the adapter is
installed.
Specifies the number of the slot the adapter is in.
Specifies the adapter's transfer rate:
•
0 (no limit)
•
10 (Fast SCSI)
•
20 (Ultra SCSI)
Get other manuals https://www.bkmanuals.com
Troubleshooting
Setting and Confirming SCSI Parameters
77