Installing The A6829A Adapter - HP A6829A User's Manual And Service Manual

Installing the A6829A Adapter

This section contains information about installing the A6829A HBA in
an HP-UX system (including Online Addition and Replacement [OLAR]).
WARNING The installation procedures in this section require opening the
computer cabinet, which might expose you to high-energy
(high-amperage) circuits and sharp edges in the equipment
chassis. Be sure to remove all rings, watches, and other jewelry
before opening the cabinet.
CAUTION The A6829A adapter contains electronic components that can easily be
damaged by small amount of static electricity. To avoid damage, follow
these guidelines:
•
•
•
•
•
•
Before beginning installation, and without removing the adapter from its
antistatic bag, inspect the adapter for any signs of obvious damage, such
as chipped or loose components. Contact Hewlett-Packard if the adapter
is damaged.
Install the A6829A in your HP-UX system according to the
documentation for the system.
Chapter 2
Store the adapter in its antistatic plastic bag until you are ready to
install it.
Work in a static-free area, if possible.
Handle the adapter by the edges only. Do not touch electronic
components or electrical traces.
If you must lay the adapter down, place it on a non-conductive mat or
surface.
Use the ESD kit that is provided with the adapter. Follow the
instructions included with the kit.
Use a suitable ground—any exposed metal surface on the system
chassis.
Get other manuals https://www.bkmanuals.com
Installing the A6829A Adapter
Installing the A6829A Adapter
15