HP A6829A User's Manual And Service Manual page 89

Setting and Confirming SCSI Parameters for HP
A6829A Host Bus Adapters Installed in PA-RISC Based
Systems
If the HP A6829A SCSI host bus adapter is installed in a supported
PA-RISC based system, use the SCSI command to display and select
SCSI parameters.
The SCSI command is available from the boot menu displayed after the
test station has booted (if autoboot is disabled). In the following
illustration of the boot menu display, the SCSI command is emphasized
with bold type:
Command
-------
AUto [BOot|SEArch ON|OFF]
BOot [PRI|ALT|<path> <args>]
BootTimer [time]
CLEARPIM
CPUconfig [<proc>] [ON|OFF]
DEfault
DIsplay
ForthMode
IO
LS [<path>|flash]
OS [hpux|sppux]
PASSword
PAth [PRI|ALT|CON] [<path>]
PDT [CLEAR|DEBUG]
PIM_info [cpu#] [HPMC|TOC|LPMC]
RESET [hard|debug]
RESTrict [ON|OFF]
SCSI [INIT|RATE] [bus slot val]
SEArch [<path>]
SECure [ON|OFF]
TIme [cn:yr:mo:dy:hr:mn[:ss]]
VErsion
Chapter 3
Description
-----------
Display or set the specified flag
Boot from a specified path
Display or set boot delay time
Clear PIM storage
Configure/Deconfigure Processor
Set the sytem to defined values
Display this menu
Switch to the Forth OBP interface
List the I/O devices in the system
List the boot or flash volume
Display/Select Operating System
Set the Forth password
Display or modify a path
Display/clear Non-Volatile PDT state
Display PIM of current or any CPU
Force a reset of the system
Display/Select restricted access to Forth
List/Set SCSI controller parms
Search for boot devices
Display or set secure boot mode
Display or set the real-time clock
Display the firmware versions
Get other manuals https://www.bkmanuals.com
Troubleshooting
Setting and Confirming SCSI Parameters
75