JVC GY-HC900CHE Instructions Manual page 175

c Media Status
---- : A card is not detected in the
selected slot, and [Tally
System] is also not set to
"Studio"
STBY : Recording standby
: Recording
RREC
REVIEW : Clip Review
(A P86 [Viewing Recorded Videos Immediately
(Clip Review)] )
: Pre Rec recording standby
STBY P
(A P92 [Pre Rec] )
: Pre Rec recording
RRECP
(A P92 [Pre Rec] )
: Clip Continuous Rec recording
STBY C
standby
(A P93 [Clip Continuous Rec] )
: Clip Continuous Rec recording
RRECC
(A P93 [Clip Continuous Rec] )
: Clip Continuous Rec recording
STBYC
pause
(displayed in
yellow)
(A P93 [Clip Continuous Rec] )
: Interval Rec recording standby
STBY N
(A P95 [Interval Rec] )
: Interval recording pause
STBYN
(displayed in
red)
: Interval Rec recording
RRECN
(A P95 [Interval Rec] )
: Frame Rec recording standby
STBY M
(A P94 [Frame Rec] )
: Frame Rec recording
RRECM
(A P94 [Frame Rec] )
: Frame Rec recording pause
STBYM
(displayed in
yellow)
(A P94 [Frame Rec] )
STOP : Unable to record to the card in
the slot
P.OFF : Power OFF
: During clip cutter recording
Q
(displayed for 3 seconds)
(A P96 [Splitting the Clips Freely (Clip Cutter
Trig)] )
CALL : Receiving call signals from an
external device, such as a
remote control unit
PGM : Receiving program signals
from an external device, such
as a remote control unit
PVW : Receiving preview signals
from an external device, such
as a remote control unit
d Live streaming mark
When [Network] B [Live Streaming] B [Live
Streaming] is set to "On", the distribution status
is displayed.
(A P145 [Live Streaming Item] )
Icon
Distribution in progress (good
connection quality)
.
(Red)
Distribution in progress (poor
connection quality)
.
(Red)
Waiting for connection
(RTSP/RTP only), connection
failed
.
(Yellow)
e SDI Input Mode/High-Speed Frame Rate
"SDI INZ" is displayed when a device is
0
connected to the [HD/SD SDI IN] terminal,
and [System] B [Record Set] B [Record
Format] B [System] is set to "HD(SDI In)" or
"SD(SDI In)".
When [System] B [Record Set] B [Record
0
Format] B [System] is configured to "High-
Speed", the setting value for [WFrame Rate]
is displayed.
f OK Mark
Displayed when OK mark has been appended.
(A P103 [Appending/Deleting OK Mark] )
g Recording Format/Bit Rate (Enlarged Display
Mode Only)
Displays the recording format and bit rate (only
when in the enlarged display mode).
Memo :
The resolution, frame rate and bit rate can be
0
viewed on the status screen.
h Event/Warning Display Area
Displays error messages.
(A P237 [Error Messages and Actions] )
i Dual Rec/ Backup Rec Display (Enlarged
Display Mode Only)
"DUAL" is displayed in the Dual Rec mode and
"BACKUP" is displayed in the Backup Rec
mode.
(A P164 [ Slot Mode ] )
Memo :
Displayed only when in the enlarged display
0
mode.
Display Screen in Camera Mode
Status
175