JVC GY-HC900CHE Instructions Manual page 135

9 Resolution (SDI OUT2)
For selecting the resolution of video output from the
[HD/SD SDI OUT2] terminal according to the
monitor to be connected.
[Setting Values: 1080psF/i, 1080p, R1080i, 720p,
576i, 480i]
Memo :
The selectable options vary according to the
0
setting in [System]/[WResolution] and [WFrame
Rate] of [System] B [Record Set] B [Record
Format].
Cross conversion output is not possible.
0
When "Return Video" is selected for [SDI
0
OUT2], signal is output from the [HD/SD SDI
OUT 2] terminal at 1080p.
3G-SDI Mapping
For configuring the mode of mapping for signals
output from the [HD/SD SDI OUT] terminal.
[Setting Values: Level B, RLevel A]
Memo :
This item can be configured only when [SDI
0
OUT1] B [Resolution] or [SDI OUT2] B
[Resolution] is set to "1080p".
When [SDI OUT1] or [SDI OUT2] is configured
0
to "Off", this item cannot be configured.
SDI Rec Trigger
For configuring whether to superimpose trigger
signals on the [HD/SD SDI OUT] terminal in tandem
with the [REC] button.
If "Type-A" or "Type-B" is specified, it is possible to
record on a device equipped with SDI record trigger
in tandem with the operation of the [REC] button.
When a compatible device is connected,
recording/stop control signals are output in tandem
with the operation of the [REC] button.
The SDI record trigger output status to the
connected device is indicated by REC B/STBY B
on the display screen.
[Setting Values: Type-A, Type-B, ROff]
Memo :
If "Type-A" does not work, it may operate in the
0
"Type-B" setting, but the user's bit to the
connected device will not be correctly output.
Even if REC B/STBY B is displayed on the
0
display screen, the compatible device may not
necessarily be recording.
This item can be configured when [SDI OUT1]
0
is set to "On" or [SDI OUT2] is set to a setting
other than "Off", and [Rec Mode] is set to
"Normal", "Pre Rec" or "Clip Continuous".
Set to "Off" if connecting to a device that does
0
not support record trigger.
135
A/V Set Menu