Display Type Item - JVC GY-HC900CHE Instructions Manual

Display Type Item

This menu is used to set the displays on the LCD
monitor and viewfinder screen.
Battery
For setting the display of the remaining battery
power on the LCD monitor and viewfinder screen.
Time:
0
Displays the remaining battery power in
minutes. (min)
Capacity%:
0
Displays the remaining battery power in
percentage. (%)
Voltage:
0
Displays the current battery voltage in units of
0.1 V. (V)
[Setting Values: RTime, Capacity%, Voltage]
Memo :
The battery mark that appears before the "Time",
0
"Capacity%" or "Voltage" value changes according to
the remaining battery power.
I : Battery which the capacity could not be
acquired
4 : Below 13%
D : 13% or higher
C : 30% or higher
B : 60% or higher
F : Battery communication error
J : Calibration required
While "Time" or "Capacity%" is displayed, "E"
0
appears when the level falls below the setting in
[System] B [Battery] B [Near End (%)]. Replace the
battery as soon as possible.
The remaining battery power and remaining time are
0
intended as reference values for the shooting
duration.
When the battery that is connected does not support
0
communication, the voltage is displayed regardless
of the setting.
Zoom
For setting the display method of the zoom
position.
Number:
0
Displays the zoom position in numbers (Z00 to
99).
Bar:
0
Displays the zoom position in a bar.
[Setting Values: Number, RBar]
Memo :
This item will not be displayed if the lens
0
attached does not support zoom position
information.
132
LCD/VF Menu
Focus
For setting the display method of the approximate
distance to the subject in focus during manual
focus.
Feet:
0
Displays the distance in feet.
Meter:
0
Displays the distance in meters.
[Setting Values: Feet, RMeter]
Memo :
This item will not be displayed if the lens
0
attached does not support focus position
information.
Shutter
For setting the shutter display to be displayed on
the LCD monitor and viewfinder screen.
DEG:
0
Displays the shutter speed in degrees in the
same way as film cameras.
SEC:
0
Displays the shutter speed in seconds.
[Setting Values: DEG, RSEC]
Memo :
"DEG" is selectable only when [WFrame Rate]
0
is set to "24p" or "25p".
When [WFrame Rate] is set to other values, the
shutter display setting is fixed at "SEC" and
cannot be selected.
(A P161 [WFrame Rate/
When a remote control unit is connected to the
0
[REMOTE] terminal, "SEC" is displayed and
selection is disabled.
Frame Rate] )