Table of Contents
Advertisement
Battery Holder Battery Replacement & Battery Back up if 120 volt power is lost
Proflame II Battery Holder Battery Replacement & Battery Pack Up if 120 Volt Power is lost
witihin home
To operate the stove during a power outage or when power is not available see the following steps.
How to replace/add the batteries on battery holder (Proflame 2).
Note : If a wall switch cover plate is installed, first remove cover plate by removing 2 small phillips head screws
STEP 1
STEP 2
STEP 3
STEP 4
Reinstall wall cover plate with 2 Phillips head screws.
Move both the left/right slides
as shown below.
Extract the battery
compartment from the remote
receiver/battery holder
Keeping the battery compartment
pressed in, close the left slide
operating instructions
The battery compartment
will be pushed out slightly,
to allow to easily extract it
Replace 4 x AA batteries and insert the battery
compartment back into remote receiver/battery holder
Close the right slide
Regency
U39E-12 ULTIMATE™ Freestanding Gas Stove
®
|
47
Advertisement
Table of Contents
