Table of Contents
Advertisement
maintenance
Valve Replacement
If the valve requires maintenance or replacement,
use the following instructions:
Note: Always shut off the gas supply and
turn off electrical before removing
the valve.
1. Remove safety screen and open front pedestal
door. You may want to put a soft cloth on the
base of the unit so that when the pedestal door
is open it doesn't scratch the paint.
2. Remove 2 screws to remove receiver cover.
3. Remove chain from door and unit,remove 4
screws holding the access panel in place.
Receiver cover
Chain slot
4. Disconnect receiver wire from the back of the
panel and then remove panel. Set the panel
on a soft cloth so it doesn't get scratched.
5. Disconnect stepper motor wire.
Stepper motor wire
6. If the fan is installed–disconnect the "COM" wire
from the valve.
7. Disconnect the DC spark generator wires from
the valve.
|
52
Regency
U39E-12 ULTIMATE™ Freestanding Gas Stove
®
8. Disconnect the gas at the valve. Access through
the front (with access panel removed) The gas
line may also be accessed by removing the rear
pedestal cover plate.
9. Carefully remove the logs and lava rock.
10. Remove two (2) screws to remove burner.
t t o o o o l l t t i i p p
Note: Use a magnetic type screwdriver if
possible.
11. Remove all 18 screws holding the burner tray
assembly in place.
Access panel
12. Carefully lift the valve tray assembly out.
13. Remove the valve tray and replace.
14. Reverse Steps 1-11 to complete.
Advertisement
Table of Contents
