Table of Contents
Advertisement
maintenance
FAN MAINTENANCE
If your fan requires maintenance or replacement,
access to the fan is through the plate on the rear
wall of the firebox. NOTE: the unit MUST NOT be
operated without the fan access panel securely
in place and correctly sealed.
IMPORTANT: These fans collect a lot of dust from
within your home. Ensure you maintain
these fan motors on a regular basis by
vacuuming out the fan squirrel cages,
around the motor, and around the grills
on the back of the stove.
IMPORTANT
Disconnect power supply
before servicing
WARNING:
Electrical Grounding
Instructions
This appliance is equipped with a
three pronged (grounding) plug
for your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not
cut or remove the grounding
prong from this plug.
44 |
Regency
U39-11 ULTIMATE™ Freestanding Gas Stove
®
To Remove U39 Fan from front of Unit:
1. Unplug or disconnect power source to stove.
2. Remove all logs and the rear log support, then
remove the 10 screws holding the access panel
in place.
3. Unclip the black and white wires from the fan
motor.
4. Open both side doors and gently pull the flex
pipe away from the center, otherwise the fan
can catch on the flex pipe during installation
and tear the pipe. Do not tear or damage the
flex pipe.
Alternate Fan Access:
If the rear access cover is
accessible, it can be removed
to provide access to the fan.
5. Lift fan off of the 2 pins, tip back and pull through
firebox opening. Disconnect the green ground
wire from the right side of the fan as soon as
accessible.
Unclip these
2 wires
Fan
Grommet
Pin
Fan Access Panel
Thermodisc
Replacing U39 Fan:
Reverse the above steps (1 - 5). If necessary install
a new gasket before replacing the fan access panel.
Make sure the fan wires and the ground wire are
reattached.
Hint for pushing fan down onto pins - rub a bit
of dish soap on the grommet so it will slide more
easily onto the pin. Check to make sure the fan is
seated properly on the pins - try to move the fan
back and forth, there should be no noise, if there
is check that the grommets haven't come loose.
DC SPARKER BATTERY
REPLACEMENT
The battery in the DC Spark box needs to be re-
placed annually.
See DC Spark Box battery installation in this manual.
Access
Panel
Gasket
Pin
Advertisement
Table of Contents
