Table of Contents
Advertisement
Proflame II Remote Control Operating Instructions
IMPORTANT:The Proflame Transmitter 2 is an integrated part of the
Proflame 2 System, which consists of these elements:
•
Proflame 2 Transmitter, to be used in conjunction with:
•
Integrated Fireplaces Control (Proflame 2 IFC)
The Proflame 2 Transmitter provides for controlling the following hearth
appliance functions:
1. Main Burner On/Off
2. Main Burner flame modulation (6 levels)
3. Choice of standing or intermittent pilot (CPI/IPI)
4. Thermostat and Smart thermostat functions
5. Accent light modulation (6 levels)**
6. Split flow valve**
7. Comfort Fan speed modulation (6 levels)**
** This feature is not available on any Hampton models.
The Proflame Transmitter uses a streamline design with a simple button
layout and informative LCD display (Fig. 1). A Mode Key is provided to
index between the features and a Thermostat Key is used to turn on/
off or index through Thermostat functions (Fig. 1 & 2). Additionally, a
Key Lock feature is provided (Fig. 22).
Figure 1: Proflame Transmitter
Figure 2: Transmitter LCD Display
TECHNICAL DATA
REMOTE CONTROL
Supply Voltage
Ambient temperature
ratings
Radio Frequency
WARNING: THE TRANSMITTER AND IFC ARE RADIO
FREQUENCY DEVICES.
ATTENTION!
- Turn "OFF" the main gas supply of the appliance during installation
or maintenance of the IFC.
- Turn "OFF" main gas supply to the appliance prior to removing or
reinserting the batteries.
- In case of remote control malfunction, turn off the IFC device using
the "ON/OFF" main switch.
- For installation / maintenance, switch off the IFC device removing
main power supply plug.
OPERATING PROCEDURE
Pairing the Remote Control to IFC (If required)
Power the receiver. Press the PRG button located on the top right hand
corner of receiver. The receiver will beep three times to indicate that
it is ready to synchronize with a transmitter. Install the 3 AAA type
batteries in the transmitter battery bay, located on the base of the
transmitter (fig. 3). With the batteries already installed in the transmit-
ter, opush the ON button. The receiver's command is accepted and sets
to the particular code of that transmitter. The system is now initialized.
(*) The receiver may be independent or integral jto the IFC hearth appliance
control module. The receiver instruction may not be independent when
part of the IFC.
Figure 3: Battery Compartment
Regency
U39E-12 ULTIMATE™ Freestanding Gas Stove
®
owner's information
4.5V (three 1.5V AAA batteries)
0 - 50
C (32 - 122
F)
o
o
315 MHZ
|
11
Advertisement
Table of Contents
