Programming Opener And Accessories: Introduction - Genie Pro Series Installation, Programming, & Operation

OPENER PROGRAMMING & ACCESSORY INSTALLATIONS
5
NOTE: Before programming the opener, check to make sure there are no objects in the garage door opening. DO NOT allow
persons to enter the area of the door while programming and operating.
The following steps list the order of programming the opener's functional settings as well as installation of any
accessories that were included with the opener or purchased separately. These steps should be performed in order.
1. Adjust opener speed for drum sizes.
2. Down Travel Limit
3. Up Travel Limit
4. Force Control
5. Contact Reverse test and adjustment
6. Remote Control Programming
7. Remote control(s), Lighting fixture and Wireless Wall Console included with this opener are programmed at the
factory. The information provided on these pages should be used if adding additional remote controls, wireless wall
consoles or light fixtures.
8. Accessory Installation and/or Programming
9. Program wireless keypad (If applicable)
10. Program built in vehicle remote (If applicable)
11. Program the Integrated Aladdin Connect™ (If applicable)
12. Install Battery Backup (BBU) (If applicable)
NOTE: When opener is activated to close, opener will start and stop slowly in small increments to detect cable
tension then run at normal speed to close. This is normal operation.
Programming Button Layout
NOTE: Each programming step has a 30 second time limit for completion after the function is initiated. After 30 seconds, both LED's
will illuminate RED indicating time has expired and the step must be restarted. Restart the step as many times as necessary to
complete the programming.
16
Wi-Fi Program
Program/Set
Long LED
Indicator
Round LED
Indicator
Wi-Fi LED
Close Travel
Button
Open Travel
Button