Table of Contents
Advertisement
OPENER PROGRAMMING & ACCESSORY INSTALLATIONS
3
NOTE: Before programming the opener, check to make sure there are no objects in the garage door
opening. DO NOT allow persons to enter the area of the door while programming and operating.
The following steps list the order of programming the opener's functional settings and install any
accessories that were included with the opener or purchased separately. These steps should be
performed in order.
1.
Down Travel Limit
2.
Up Travel Limit
3.
Force Control
4.
Contact Reverse test and adjustment
5.
Remote Control Programming
• Remote control(s) included with this opener are programmed at the factory. The information
provided on this page should be used if adding additional remote controls.
6.
Accessory Programming
• Program wireless keypad (If applicable)
• Program built in vehicle remote (If applicable)
• Program wireless wall console (If equipped)
• Program the Integrated Aladdin Connect (iDCM) if equipped.
7.
Install Battery Backup (If equipped)
Term Definitions:
Travel Limits Programmable setting to adjust how far door travels up or down.
Force Control refers to how much power is needed to move (open/close) a
particular door and does NOT require programming.
Remote & Accessory Programming synchronizes remote devices with the
powerhead.
(Remote Controls, Wireless Keypad, Homelink®, Car-2-U® Systems)
NOTE: Each programming step has a 30 second time limit for completion after the function is initiated. After 30
seconds, both LED's will illuminate RED indicating time has expired and the step must be restarted. Restart the
step as many times as necessary to complete the programming.
Programming Button Layout
Program/Set
Open Travel
Button
Long LED
Indicator
DOOR
Close Travel
Button
Round LED
Indicator
5
Hide quick links:
Advertisement
Table of Contents
