Transmitter Programming - Genie GCL-MT Manual

Transmitter Programming

Adding a Transmitter
1. If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2. Press SCROLL (up or down) until display reads "LEARN NEW XMTR? " Fig.1
• This question along with the instruction "HIT SET FOR YES" will continuously pan across the display
window. (Pressing SCROLL or CAL/RUN will cancel the operation.)
3. Press SET/CLEAR .
• Display will read "PUSH XMTR BUTTON TWO TIMES TO LEARN XMTR. "
4. Press Transmitter button two times.
• The display will read "XMTR ___LEARNED. " Where it assigns a random number to the transmitter. That
transmitter is entered and ready to operate the door. (Label/mark the transmitter.)
5. Press SCROLL (up or down) to move on to another menu item, or CAL/RUN to exit the CAL mode.
Removing Individual Transmitter
1. 1) If operator is in RUN mode, press CAL/RUN to enter calibration mode.
2. Press SCROLL (up or down) until display reads "REMOVE XMTR? " Fig.2
• This question along with the instruction "HIT SET FOR YES" will continuously pan across the display
window. (Pressing SCROLL or CAL/RUN will cancel the operation.)
3. Press SET/CLEAR
• A menu displaying the available transmitter numbers will appear.
• Press SCROLL (up or down) to cycle through the menu to the number of the transmitter to be removed.
(Pressing CAL/RUN will cancel the operation.)
4. Press SET/CLEAR
• The transmitter is removed.
5. Press SCROLL (up or down) to move on to another menu item, or CAL/RUN to exit the CAL mode.
LEARN NEW XMTR?
CAL
RUN
Fig. 1
Removing All Transmitters
1. If operator is in RUN mode, press CAL/RUN to enter calibration
mode.
2. Press SCROLL (up or down) until display reads "REMOVE ALL
XMTRS" Fig.3
• This question along with the instruction "HIT SET FOR YES"
will continuously pan across the display window. (Pressing
SCROLL or CAL/RUN will cancel the operation.)
3. Press the SET/CLEAR key.
• The display will read "ARE YOU SURE. "
4. Press SET/CLEAR key.
• All transmitters are removed.
5. Press SCROLL (up or down) to move on to another menu item, or CAL/RUN to exit the cal mode.
Sec-4.11
Section 4: Special Features
OPEN
CLOSE
STOP
SET
SCROLL
CLEAR
SCROLL
(Optional with addition of internal radio)
REMOVE XMTR?
CAL SET
SCROLL
RUN CLEAR
SCROLL
Fig. 2
REMOVE ALL XMTRS?
CAL
SCROLL
RUN
SCROLL
Fig. 3
OPEN
CLOSE
STOP
OPEN
CLOSE
STOP
SET
CLEAR