Pre-Installation Permanent Input Wiring - Genie Pro Series Installation, Programming, & Operation

PRE-INSTALLATION CONSIDERATIONS
If a 115V power outlet is not available within 5 feet from bottom of the opener when mounted to door, as an
option the Alternate Low Voltage Power Kit may be used (See section 9).
This task should be performed prior to mounting opener. Fully read and understand the instructions that
accompany the kit before proceeding.
PERMANENT WIRING SHOULD BE COMPLETED BY A TRAINED ELECTRICIAN ONLY:
1. Remove two screws from bottom of cover and remove main opener cover/circuit board assembly.
2. Unplug wire harnesses from main board.
3. Unplug input power cable connector from transformer input.
4. Remove transformer from chassis.
5. Remove strain relief and pull power cable from opener.
6. Install opener per instructions on pages 6 through 9.
7. Cut power cable wires and strip insulation from power cable input harness connector end.
All wire connections must be made INSIDE CHASSIS and there must be at least 3" of new power supply line wire inside chassis.
Check local code for the use of conduit or other protective material.
Conduit, fittings/strain relief, and wire nuts are not provided.
8. Install 1/2in. NPT or other suitable connector into chassis. (Adhere to local electrical code(s) and regulations)
9. Connect permanent power input cable to harness wires using approved connectors or wire nuts (Adhere to local electrical
code(s) and regulations)
10. Install ground connector to permanent power cable ground wire.
11. Install ground screw and power cable ground onto chassis.
12. Plug power input harness into transformer harness.
13. Install transformer.
14. Ensure input power cable and connections do not interfere with internal moving components.
15. Plug all harnesses into main control board and install cover assembly.
16. DO NOT APPLY POWER AT THIS TIME.
17. Continue installation starting on page 10.
(INPUT POWER WIRING OPTIONS)
Strain Relief
Cable Connector
Remove External
from power cable
chassis
Power Input
Harness
Wire Nut
Connections
5