Installing Door Lock - Genie Pro Series Installation, Programming, & Operation

Door lock prevents manual door operation and is important for garage security
Door lock should be installed no more than 10 feet away on the opener side of the door if
possible.
1. Mount door lock onto door track above a roller on the second or third door panel from the floor.
If mounting position does not line up with pre-punched door lock bar cutouts as shown below:
Remove template from the back page of the owners manual.
Apply template to the door track where the center 7/16" hole is approximately 3 inches above the door
roller on the 2nd or 3rd door panel.
Drill two 9/32" holes for mounting and one 7/16" hole if using template. De-burr holes if required.
2. Position door lock and install two 1/4" X 9/16" track bolts and nuts. Install track bolt on inside of door track
facing outward.
10
INSTALLING THE DOOR LOCK
Approx. 3"
9/32"
7/16"
Bit
7/16"
SOCKET