Genie Pro Series Installation, Programming, & Operation page 10

5) Mount opener to door shaft.
If the door shaft is NOT keyed, slide opener assembly onto door shaft and tighten setscrews finger tight.
If the door shaft IS keyed, insert provided key into either keyway. Pull emergency release cable at the bottom
of the opener to allow free rotation of the output shaft to "clock" the keyways together.
Tighten set screws onto door shaft finger tight.
NOTE: The mounting of this opener to the door shaft is designed so the door shaft will slide through the coupler
and enter the hollow output shaft of the opener up to 3 -3/8" (there is a stop pin located in the center of the
opener output shaft).
CABLE DRUM
DOOR TORSION SHAFT
8
INSTALLING THE OPENER
SOLID OR HOLLOW
DOOR SHAFT NO KEY
OPENER REMOVED FOR CLARITY
RIGHT HAND INSTALL SHOWN
DOOR
(CONT')
SOLID KEYED
DOOR SHAFT
Bracket can be
mounted to
opener on either
side depending
on mounting
requirements.
RELEASE CABLE