Table of Contents
Advertisement
Features
Begin here ONLY AFTER completing assembly and installation of the opener. Review the Assembly and Installation Poster to ensure all
steps have been performed. Visit www.GenieCompany.com to download a printable le.
SAFETY FEATURES
Safe-T-Beam® (STB) Non-Contact
Reversing System
Puts an invisible beam across the door
opening. The door stops and reverses to the full
open position if anything passes through the
beam. LED indicator lights on the powerhead
and on the STBs provide self-diagnostics if an
operational problems exists.
Safe-T-Reverse® Contact Reversing System
Automatically stops and reverses a closing door
within two seconds of contact with an object.
Door Detect™ Monitoring System
Monitors the Safe-T-Beam® system to ensure
proper functionality and will automatically
stop and reverse a closing door if a problem is
detected.
Manual Emergency Release
Manually releases door from door opener. Used
during a power failure or other emergency to
allow manual opening and closing of door.
SmartSet
Easily adjust the programming to set limits and
program new remotes.
Automatic Lighting System
Single bulb lighting system supplies light for
safer evening exits and entries. Turn ON when
door is activated and automatically turns OFF 4
minutes later.
Safe-T-Beam® (STB) FUNCTION
1. The Safe-T-Beam® has no e ect on the door during an opening cycle.
2. If the Safe-T-Beam® detects an obstruction when trying to close the
door, it will not allow the door to close.
3. When the garage door is closing, if Safe-T- Beam® is interrupted by
a person or obstacle, the garage door will stop its downward travel
and reverse automatically to its fully opened position.
4. If the Safe-T-Beam® System fails, loses power, or is installed
improperly, press and hold the wall console "open/close" button
until the door reaches its fully closed position. If you release
the "open/close" button on the wall console during the closing
movement, the door will reverse automatically to its fully-opened
position.
Electronic Programming
®
OPENER FEATURES
Intellicode®
An encryption system that enhances the security
of the door opener by continuously changing
the access code each time the remote is used.
The door opener responds to each new code
only once. An access code copied from a
working system and tried again, will not control
the door opener.
Wall Console (With selected models)
Operates door opener from inside garage.
The wall console has an indicator light with:
Open/Close, Sure-lock™, and independent
light control buttons.
Home Link® and Car2U® compatible. See page 12
in this manual, refer to your motor vehicle manual
or visit www.GenieCompany.com for instructions.
PRE-PROGRAMMED REMOTE CONTROL
For ease and speed of installation, the remote
included with this opener comes from the factory,
OR
pre-programmed. No additional steps are required
to activate the door using the remote.
NOTE: Use this manual ONLY after completing assembly and
installation of the opener.
Review the Assembly and Installation Instructions poster. Check
that all steps have been completed.
3
Hide quick links:
Advertisement
Table of Contents
