Install And Wire Optional Wired Wall Console; Install And Wire Optional External Interlock; Install Bottom Cover - Genie Pro Series Installation, Programming, & Operation

Install and Wire Basic Wall Console (Hardwired) - Optional
1. Route supplied wire from powerhead to the desired location for the hardwired wall control. Secure wire with
insulated staples.
2. On the powerhead: Remove 1/4" insulation from white and striped wire. Using a small flat head screwdriver,
press in the orange tab and insert the white wire into BWC WHITE terminal and the striped wire into BWC
BLACK terminal.
3. At the wall console end of the wire, remove 1/4" insulation from the white and striped wires and secure the
white wire to the "W" terminal and the striped wire to the "B/W" terminal as shown.
4. Mark the wall console mounting holes, drill 3/32" pilot holes and mount with #6 x 1-1/4" screws. If mounting
to drywall, anchors will be required (not provided).
B/W W
Wall Console Wires:
Striped Wire to B/W Terminal
White Wire to W Terminal
Install and Wire N/C Interlock-Optional
1. Do not remove factory installed interlock wire unless installing an interlock. This jumper is required for
proper opener operation.
2. Use of any commercially available normally closed (N/C) dry contact interlocks can be used with this
opener. Using a small flat head screwdriver, press in the orange tabs at INTER-LOCK terminals and remove
factory installed jumper wire and insert the interlock wires.
Install Bottom Cover Onto Opener -
1. Remove two screws on the sides of opener.
2. Route wires to the rear of opener to align with slot in rear
of cover.
3. Install cover with screws removed in step 1.
14
FINISHING THE INSTALLATION
B/W W
Main Activation
Sure-Loc Activation
Locks out all opener
functions (vacation lock)
Light Override
OMIT THIS STEP IF INSTALLING BATTERY BACK-UP