2.3
Setting of the terminating resistor selection switch
Always set the terminating resistor selection switch (refer to
resistor (refer to
page
27) to the inverter that is the end station (FR-A8NC) in advance.
The following table lists the specifications of the terminating resistor selection switch.
(In the initial setting, no terminating resistor is set (1: OFF and 2: OFF).)
Setting
1
2
OFF
OFF
ON
OFF
OFF
ON
ON
ON
20
INSTALLATION
Without terminating resistor (initial setting)
Do not use.
130 (resistance value with the CC-Link Ver. 1.00 dedicated high performance cable)
110
page
9) or connect the one-touch connector plug with terminating
Description