Table of Contents
Advertisement
Device no.
Signal
RWw10,
RWw12,
Link parameter
RWw14,
extended setting/
RWw16,
Instruction code
RWw18
RWw11,
RWw13,
RWw15,
Write data
RWw17,
RWw19
*1
The display can be changed to rotations per minute according to the Pr.37, Pr.144, and Pr.811 settings. (Pr.811 is only available for the
FR-A800 series.) For details, refer to the Instruction Manual (Detailed) of the inverter.
*2
When Pr.541 Frequency command sign selection = 1, the setting value has either + or -. When the setting value is negative, the
command is inversed from starting command.
Setting range: -327.68 Hz to 327.67 Hz (-327.68 to 327.67) 0.01 Hz increments
For details refer to
*3
Validity depends on the Pr.128, Pr.609, and Pr.610 settings. For the details, refer to the Instruction Manual (Detailed) of the inverter. If the
data outside the range is set, the previous setting is retained.
*4
The setting is available only for the FR-A800 series.
*5
This setting can be set only when the inverter supports this function. (Refer to
70
DETAILS OF INPUT AND OUTPUT SIGNALS
Set the instruction code (Refer to
error reference, error clear, etc. The instructions are executed in the following order by setting "1" in
RYF after completing the register setting: RWw2, 10, 12, 14, 16, then 18. After completing the
execution up to RWw18, "1" is set in RXF. Set HFFFF to disable an instruction by RWw10 to 18.
(RWw2 is always executed.)
The first 8 bits are link parameter extended setting.
Example) When reading Pr.160, instruction code is H0200.
Set the data specified by the instruction code of RWw10, 12, 14, 16, and 18. (when required)
RWw10 and 11, 12 and 13, 14 and 15, 16 and 17, and 18 and 19 correspond each other.
Set "1" in RYF after setting the instruction codes (RWw10, 12, 14, 16, and 18) and the
corresponding register.
Set "0" when the write code is not required.
page
47.
Description
page
75.) for execution of operation mode rewrite, Pr.read/write,
page
80.)
Advertisement
Table of Contents
