Table of Contents
Advertisement
Installing the option
1.
Insert two spacers into the mounting holes that will not be filled with mounting screws
2.
Fit the board mounted option connector on this product to the guide of the option connector on the inverter and insert the
plug-in option as far as it goes. (Select option connector 1 on the inverter.)
3.
Fasten the earth plate to the inverter using the one mounting screw through the hole on the left side
torque 0.33 N∙m to 0.40 N∙m).
4.
Fasten this product to the inverter using the one mounting screw through the hole on the left side. Fasten the earth plate
and this product to the inverter using the last screw through the hole on the right side of the earth plate and this product
(tightening torque 0.33 N∙m to 0.40 N∙m). If the screw holes do not line up, the connector may not be inserted deep
enough. Check the connector.
16
INSTALLATION
(page
18).
(page
18) (tightening
Advertisement
Table of Contents
