Table of Contents
Advertisement
Item
Read
Link parameter extended
*8
setting
Write
Read
Second parameter
*9
changing
Write
*1
When "100" is set in Pr.52 Operation panel main monitor selection, frequency setting is monitored during a stop and output frequency
is monitored during running.
*2
When position control is selected for the FR-A800 series, the number of pulses is monitored when Pr.430 ≠ "9999".
*3
Write data is in hexadecimal, and only last two digits are valid. (The upper two digits are ignored.)
*4
Differs according to capacities.
*5
Setting from the remote register (RWw1) is also available.
*6
Pr.811 is only available for the FR-A800 series.
*7
Turning OFF the power supply while clearing parameters with H5A5A or H55AA sets back the communication parameter settings to the
initial settings.
Setting is valid only when Pr.544 = "0". When Pr.544 "0", set using RWw2 or RWw10, 12, 14, 16, or 18. (Refer to
*8
*9
Reading or writing is available when the link parameter extended setting = "1 or 9".
*10 Gain frequencies can be written using Pr.125 (instruction code H99) and Pr.126 (instruction code H9A) also.
NOTE
• When the 32-bit parameter setting or monitor description are read and the read value exceeds HFFFF, the reply data will be
HFFFF.
78
DETAILS OF INPUT AND OUTPUT SIGNALS
Read/
Instruction
write
code
Parameter settings are changed according to the instruction code settings.
H7F
Refer to the Instruction Manual (Detailed) of the inverter for instruction code (extended)
HFF
settings.
Read or write of bias and gain parameters. For the details of the setting values, refer to
H6C
the calibration parameter list in the Instruction Manual (Detailed) of the inverter.
H00: Frequency
H01: Analog value set in parameters
HEC
H02: Analog value input from the terminal
Description
*10
page
68)
Advertisement
Table of Contents
