Table of Contents
Advertisement
NOTE
• When a communication line error has occurred, reset cannot be made from the network.
• The inverter is set to the External operation mode if it has been reset in Network operation mode in the initial status. To
resume the network operation, the inverter must be switched to the Network operation mode again. Set a value other than
"0" in Pr.340 to start in the Network operation mode. (Refer to
• Communication continues during inverter reset. The inverter cannot be controlled for about 1 s after release of a reset
command.
• Refer to
page 98
for an inverter reset program example.
Error reset operation selection at inverter fault
An error reset command from communication option can be invalid in the External operation mode or PU operation mode.
Use RY1A for an error reset command from network. (Refer to
Pr.
Name
Communication reset selection/Ready
bit status selection/Reset selection when
349
inverter errors cleared/DriveControl
writing restriction selection
*1
The same operation is performed regardless of the setting value.
44
INVERTER SETTING
page
34.)
page
63.)
Initial
Setting range
value
0, 100, 1000,
1100, 10000,
10100, 11000,
*1
11100
0
1, 101, 1001,
1101, 10001,
10101, 11001,
*1
11101
Function
Error reset is enabled independently of operation mode.
Error reset is enabled only in the network operation mode.
Advertisement
Table of Contents
