Pu Contrast Adjustment; Run Key Rotation Direction Selection; Frequency Easy Setting Function Selection/ Key Lock Function Selection - Mitsubishi Electric FR-CS82S-025 Instruction Manual

NOTE
• When with buzzer is set, the buzzer sounds if an inverter fault occurs.
5.3.4

PU contrast adjustment

Contrast adjustment of the LCD of the LCD operation panel (FR-LU08) and the parameter unit (FR-PU07) can be performed.
Decreasing the setting value lowers the contrast.
Pr.
991
PU contrast adjustment
E105
The above parameter is displayed as a simple mode parameter only when the LCD operation panel (FR-LU08) and the
parameter unit (FR-PU07) is connected.
5.3.5

RUN key rotation direction selection

This parameter is used to determine which direction the motor rotates when the RUN key on the operation panel is pressed.
Pr.
40 RUN key rotation direction
E202 selection
5.3.6 Frequency easy setting function selection/ key
lock function selection
The frequency setting value can be easily changed by simply pressing
The key operation of the operation panel can be disabled.
Pr.
161 Frequency setting / key lock
E200 operation selection
 Setting the frequency by pressing
• The frequency can be easily set by simply pressing
to be pressed to enter the setting. (To check the usual setting method, refer to
NOTE
• If the display changes from blinking "50.00" to "0.00", the setting value of Pr.161 may not be "1".
• The newly-set frequency is saved as the set frequency in EEPROM in 10 seconds after the setting is completed.
• When the frequency is set by pressing
frequency. Be aware of which value is set in Pr.1, and adjust the Pr.1 setting according to the application.
 Disabling keys on the operation panel (by holding down the MODE key
for 2 seconds)
• Keys on the operation panel can be disabled to prevent parameter changes, unexpected starts, or frequency changes.
• Set Pr.161 to "10 or 11" and then press
88
5. PARAMETERS
5.3 (E) Environment setting parameters
Name Initial value
58
Name Initial value
0
Initial
Name
value
0
Setting range
0 to 63
Setting range
0
1
Setting range
Frequency easy setting
0
function disabled.
Frequency easy setting
1
function enabled.
Frequency easy setting
10
function disabled.
Frequency easy setting
11
function enabled.
or
or on the operation panel during operation.
or , the output frequency goes up to the setting value of Pr.1 Maximum
for 2 seconds to disable the keys (the key lock function is set to be enabled).
Description
0: Lowest → 63: Highest
Description
Forward
Reverse
or on the operation panel.
Description
Key lock function
disabled.
Key lock function
enabled.
page 69.)
needs not