Table of Contents
Advertisement
Device no.
Signal
RY1A
Error reset request flag
*1
Signal names are initial values. Using Pr.180 to Pr.186, Pr.188, and Pr.189, you can change input signal functions. Note that some of
signals do not accept a command from the network according to the Pr.338 and Pr.339 settings. Refer to the Instruction Manual
(Detailed) of the inverter for details of Pr.180 to Pr.186, Pr.188, Pr.189, Pr.338, and Pr.339.
*2
For the FR-F800 series, no function is assigned in the initial setting.
*3
The signals are fixed. They cannot be changed using parameters.
*4
While "1" is set in the frequency setting command (RYD), the set frequency (RWw1) is always applied.
*5
If "1" is set in these registers at the same time while Pr.544 = "0," only one of these is executed.
*6
The torque command / torque limit setting is available only for the FR-A800 series.
*7
Refer to
page 43
*8
Torque control cannot be performed with a PM motor.
When "1" is set in RY1A at an inverter fault, the inverter is reset, then "0" is set in the error
status flag (RX1A).
for operation conditions of inverter reset.
Description
*7
DETAILS OF INPUT AND OUTPUT SIGNALS
7
65
Advertisement
Table of Contents
