Agp Routing Guidelines; 1X Timing Domain Routing Guidelines; Trace Length Requirements For Agp 1X; Trace Spacing Requirements - Intel 855GM Design Manual

R
9.2.

AGP Routing Guidelines

9.2.1.

1x Timing Domain Routing Guidelines

9.2.1.1.

Trace Length Requirements for AGP 1X

This section contains information on the 1X timing domain routing guidelines. The AGP 1X timing
domain signals have a maximum trace length of 10 inches (pin to pin). The target impedance is 55-Ω ±
15%. This maximum applies to ALL of the signals listed as 1X timing domain signals in Table 68. In
addition to this maximum trace length requirement (refer to Table 70 and Table 71) these signals must
meet the trace spacing and trace length mismatch requirements in Sections 9.2.1.2 and 9.2.1.3.

Table 70. Layout Routing Guidelines for AGP 1X Signals

1X signals
CLK_AGP
AGP_PIPE#
AGP_RBF#
AGP_WBF#
AGP_ST[2:0]
AGP_FRAME#
AGP_IRDY#
AGP_TRDY#
AGP_STOP#
AGP_DEVSEL#
AGP_REQ#
AGP_GNT#
AGP_PAR
9.2.1.2.

Trace Spacing Requirements

AGP 1X timing domain signals (refer to Table 68) can be routed with 4-mil minimum trace separation.
9.2.1.3.

Trace Length Mismatch

There are no trace length mismatch requirements for 1X timing domain signals. These signals must meet
minimum and maximum trace length requirements.
®
Intel 855GM/855GME Chipset Platform Design Guide
Max. Length (inches)
10
10
10
10
10
10
10
10
10
10
10
10
10
AGP Port Design Guidelines
Width (mils) Space (mils)
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
4
179