Pressure Regulator Removal; Side Trim And Side Panel Removal - Viking VGCC530 Service Manual

Hide thumbs Also See for VGCC530:

Table of Contents

Disassembly

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test

procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.

Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Pressure Regulator Removal

Condition Requirements:

Manifold Assembly Removed

Gas leak hazard. To avoid risk of personal injury

or death, leak testing of the appliance must

be conducted according to the manufacturer's

instructions. Before placing appliance in operation,

always check for gas leaks with soapy water solution.

DO NOT USE AN OPEN FLAME TO CHECK FOR

GAS LEAKS.

1. Remove pressure regulator from manifold.

2. Reverse procedure for installation.

3. Perform gas leak test.

Condition Requirements:

Control Panel Assembly Removed

Backguard Assembly Removed

1. Remove two screws and lift kick plate from keyhole

screws.

2. Remove two screws and side trim from range.

3. Remove screw and side trim support from range.

4. Remove four screws and side panel from range.

5. Reverse procedure for installation.

Table of Contents