To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Broil Burner Igniter Removal
Condition Requirements:
Door Assembly Removed
1. Remove two screws and pull igniter wire into oven
cavity.
2. Disconnect wire to remove igniter from range.
3. Reverse procedure for installation.
Oven Control Removal
Condition Requirements:
Control Components Accessed
1. Mark and disconnect four connectors from the oven
control.
2. Remove two screws, bezel, and the oven control
from the control panel assembly.
3. Reverse procedure for installation.
©2009 Viking Preferred Service
Direct Spark Module Removal
Condition Requirements:
Control Components Accessed
1. Remove three screws and slide component tray
forward.
2. Mark and disconnect four connectors from direct
spark module.
3. Remove four screws and direct spark module from
component tray.
4. Reverse procedure for installation.
Door Switch Removal
Condition Requirements:
Control Components Accessed
1. Remove two screws and door switch from range.
2. Mark and disconnect two connectors from door
switch.
3. Reverse procedure for installation.
Disassembly
25