Door Hinge Removal; Door Logo Removal; Temperature Sensor (Rtd) Removal - Viking VGCC530 Service Manual

Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless test
procedures require power to be connected. Discharge capacitor through a resistor before attempting to service.
Ensure all ground wires are connected before certifying unit as repaired and/or operational.

Door Hinge Removal

Condition Requirements:
Outer Door Panel Assembly Removed
1. Remove four screws and hinge from inner door
panel.
2. Remove screw and hinge support from hinge.
Note: Use care with insulation, make sure to replace
any damaged or missing insulation. Keep vent
on inner door panel clear of insulation.
3. Reverse procedure for installation.

Door Logo Removal

Condition Requirements:
Outer Door Panel Assembly Removed
1. Remove two pal nuts and logo from outer door panel.
2. Reverse procedure for installation.
22

Temperature Sensor (RTD) Removal

Condition Requirements:
Door Assembly Removed
1. Remove two screws that attach the sensor to the
back of the oven liner.
2. Pull the sensor from the liner until the sensor
connector protrudes into the oven cavity.
Note: The connector will not come through the hole in
the oven liner.
3. Apply side pressure to the sensor connector to
secure the connector against the opening in the oven
liner.
4. While maintaining side pressure on the connector,
disconnect the old sensor and connect the new
sensor.
Note: When installing the oven sensor, it may be
helpful to insert a small screwdriver or awl into
the connector and push the wiring and connector
into place.
5. Install two screws that attach the sensor to the back
of the oven liner.
©2009 Viking Preferred Service