Broil Burner Removal; Broil Ignitor Removal; Indicator Light; Oven Light Switch - Viking VGR30 Service Manual

INFRARED BURNE

BROIL BURNER REMOVAL

1. Shut off power to the unit.
2. Shut off the gas supply.
3. Move the range out of the opening.
4. Disconnect the gas supply.
5. Remove the four (4) screws attaching the rear vent
and remove the vent. (Backguard, high shelf or
island trim.)
6. Remove the large pal nut securing the broiler to
the supply tubing and the spud assembly.
7. Remove the oven door. (See oven door removal.)
8. Remove two (2) broil ignitor mounting screws and
remove the ignitor from the broil burner.
9. Remove the broil burner mounting screws securing
the burner to the oven cavity.
10. Remove the broil burner.

BROIL IGNITOR REMOVAL

1. Shut off power to the oven.
2. Remove the two (2) broil ignitor mounting screws
and pull the ignitor leads into the oven cavity.
3. Disconnect the wire leads.
INDICATOR LIGHTS
There is an indicator light for each oven thermostat.
The oven indicator light should be on during bake or
broil operations. This light will cycle on and off with
the thermostat cycling.
A voltage test can be made to check the indicator light
operation. Access the indicator lights by removing the
control panel. Attach the leads from a voltmeter set to
measure 120VAC or a test light to the indicator
terminals and turn the oven on to bake operation. If
voltage is present at the indicator terminals or the tester
lights up, and the indicator does not light, replace the
indicator.

OVEN LIGHT SWITCH

The oven light switches are mounted in the control
panel. The light switch can be checked for continuity
by using an ohmmeter set to the low ohms range or a
continuity tester.
Access to the switch can be made by removing the
control panel. Disconnect the wires from the switch.
Attach the meter or tester leads to the switch terminals.
Continuity or low ohms should be indicated when the
switch contacts are closed and no continuity or infinite
ohms indicated when the switch contacts are open. If
the switch fails this test, it must be replaced.

OVEN LIGHT SWITCH REMOVAL

1. Shut off power to the unit.
2. Remove the control panel. (See control panel
removal.)
3. Disconnect the wires from the switch.
4. Push the switch forward and out of the control
panel.

OVEN GASKET REMOVAL

1. Remove the oven door. (See oven door removal.)
2. Open the hinge to the broil position.
3. Loosen the upper and lower phillips head screws
(located behind the oven gasket) that secure the
hinge to the front frame.
4. Pull the gasket from the frame.

CONVECTION FAN REMOVAL

1. Shut off power to the oven.
2. Remove the door. (See oven door removal._
3. Remove the oven racks.
4. Remove the hex head screws securing the fan cover
to the rear wall of the oven
5. Remove the hex head screws securing the fan
mounting box to the rear wall of the oven, (being
careful not to allow the motor wires to come loose
and fall behind the rear wall of the oven)
disconnect the wiring one lead at a time and
29