Oven Door Assembly; Hinge And Logo Removal; Door Hinge Removal; Oven Door Parts - Viking VGR30 Service Manual

OVEN DOOR ASSEMBLY

1. Remove oven door and put on a protected table or
counter top. (See oven door removal.)
2. Remove screws securing the door panel to the door
liner and remove the panel from the liner.
3. Remove the inner baffle, the window trim and the
glass window from the door panel.
4. The door handle is mounted to the door panel and
can be removed by removing the four (4) screws.
5. Remove the insulation plate and insulation from
the liner.
6. Remove the screws securing the window brackets
to the door liner and remove the brackets.
7. Remove the door window retainer and remove
window assembly.
HANDLE and LOGO REMOVAL
1. Remove door. (See door removal.)
2. Remove screws securing the door panel to the door
liner and remove panel form the liner.

OVEN DOOR PARTS

A. Logo
B. "J" molding
C. Door Handle Bracket
D. Door Handle
E. Outer Door Glass Retainer
F. Heat Baffle
G. Insulation (32 ½" x 16 7/8")
H. Inner Door Glass Retainer
J. Inner Door Glass
3. Door handle is mounted to the door panel and can
be removed by removing four (4) screws.
4. Remove the two (2) cap nuts securing the logo to
the outer door panel.

DOOR HINGE REMOVAL

1. Remove door. (See oven door removal.)
2. Remove oven racks, rack supports, oven bottom
and inner side wall.
3. Remove two (2) screws securing the hinge cover to
the oven side wall.
4. Open the hinge and lock in the most open position.
5. Remove the lower and upper Phillips head screws
(located behind the oven gasket) securing the hinge
to the front frame.
6. Remove the hinge to the inside of the oven by
pulling through the hinge slot.
K. Door Glass Seal
L. Inner Door Liner With Window
M. Insulation Retainer With Window
N. Outer Door Glass
O. Outer Door Panel With Window
#. Upper Door Brace (Used on 36" models only)
#. Lower Door Brace ( Used on 3 6" models only)
23