Table of Contents
Advertisement
en Basic operation
Do not pour vinegar into the dis-
¡
pensers → Page 36 of the intelli-
gent dosing system
Basic operation
13 Basic operation
Basic operation
13.1 Switching on the appli-
ance
Note: If you switch the appliance on
the first time after you have connec-
ted it to the electrical system, the
switch-on process takes up to one
minute.
Requirement: The appliance has
been correctly installed and connec-
ted.
→ "Installation and connection",
Page 12
Press .
▶
The switch-on process takes a few
seconds.
An audible function test is carried
a
out.
Note: The lighting for the drum goes
out automatically.
13.2 Setting a programme
Press the required programme.
1.
→ "Programmes", Page 27
32
If required, adjust the programme
2.
settings.
→ "Adjusting the programme set-
tings", Page 32
13.3 Adjusting the pro-
gramme settings
Requirement: A programme is set.
→ "Setting a programme", Page 32
Adjust the programme settings.
▶
→ "Buttons", Page 24
Observe the information about op-
erating logic → Page 18.
Notes
The programme settings are not
¡
saved permanently for the pro-
gramme.
The setting is saved if you activate
¡
or deactivate the intelligent dosing
system.
13.4 Saving the programme
settings
You can save your individual pro-
gramme settings as favourites.
Requirements
A programme is set.
¡
→ "Setting a programme",
Page 32
The programme settings have
¡
been adjusted.
→ "Adjusting the programme set-
tings", Page 32
Press and hold Memory for ap-
▶
prox. 3 seconds.
Press Memory to call up the saved
programme.
Note: To overwrite the saved pro-
gramme, repeat the steps above.
Advertisement
Table of Contents
