Table of Contents
Advertisement
Chapter 6 Maintenance — Light source/temperature indicators
Light source/temperature indicators
When an indicator lights up
If a problem occurs inside the projector, the light source indicators <光源1>/<光源2> or temperature indicator <温
度> will inform you by lighting or blinking. Check the status of the indicators and take following measures.
Attention
f When switching off the projector to deal with problems, make sure to follow the procedure in "Switching off the projector" (x page 60).
Light source indicators <光源1>/<光源2>
Indicator status
The light source on one side is turned
Blinking in red
off since the projection lens cannot be
(1 time)
detected.
Some of the elements of the light
Blinking in red
source are defective and the light
(2 times)
output has decreased.
The light source does not light up,
Blinking in red
or the light source turns off while the
(3 times)
projector is in use.
Note
f If the light source indicators <光源1>/<光源2> are still lit or blinking after taking the measures, set the <主电源> switch to <关>, and ask
your dealer for repairs.
f The light source indicator corresponding to the light source being lit will light up in green if the projector is in projection mode and there is no
indication of problem by lighting or blinking in red.
178 - ENGLISH
Light source indicator < 光源 １>
Status
f Turn off the power and mount the projection lens again. (x page 41)
f Turn the <主电源> switch to <关> (x page 60), and turn on the power
again. The light source indicators <光源1>/<光源2> may not light up or
blink.
f Turn the <主电源> switch to <关> (x page 60), and turn on the power
again. The light source indicators <光源1>/<光源2> may not light up or
blink.
Light source indicator < 光源 ２>
Temperature indicator < 温度 >
Solution
Advertisement
Table of Contents
