Upper Cooling Fan; Terminal Block - Wolf E Series Technical & Service Manual

Component Access & Removal
IN ORDER TO REMOVE THE FOLLOWING COMPO-
NENTS, THE ENTIRE OVEN WILL HAVE TO BE
REMOVED FROM ITS INSTALLATION.
Upper Cooling Fan Removal
The upper cooling fan is located in the top left rear cor-
ner of the unit. Screws pass through the rear panel and
secure into the cooling fan assembly.
To remove the upper cooling fan, the top rear panel
must be removed first:
1. Extract screws from air diverter located in front of
the cooling fan and remove. (See Figure 4-17)
2. Disconnect electrical leads from fan motor termi-
nals.
3. Extract the three screws at the rear of unit which
secure cooling fan to the unit frame and remove.
Terminal Block Removal
The terminal block is located in the right rear corner of
the unit and is secured in position by retaining clips
under the small module top cover.
To remove the terminal block:
1. Disconnect power supply from terminals.
2. Extract screws from small top module cover.
(See Figure 4-18)
3. Turn module cover over and remove wire leads.
Label as needed to assure proper reconnection.
4. Press in on the retaining clips and push terminal
block through module cover. (See Figure 4-19)
E E - - S S e e r r i i e e s s W W a a l l l l O O v v e e n n
E E - - S S e e r r i i e e s s W W a a l l l l O O v v e e n n
Screws
Figure 4-17. Top Cooling Fan Removal>
Figure 4-18. Small Top Module Cover Removal
Red Wire
Retaining
Clips
Figure 4-19. Terminal Block Removal.
4-8
Electrical Leads
Screws
Green Wire
Black
Wire