Assembling The Throttle Lockout, Throttle And Spring - Husqvarna T425 Workshop Manual

Safety equipment
5
Unhook the carburettor from the throttle actuator
rod.
6
Remove the throttle actuator rod D. Press out pin E
to loosen the throttle F and spring G.
Cleaning and checking
• Clean and check carefully all components.
Parts must be replaced if cracked or show
signs of other defects. Always use original
spare parts.
• Check that the spring is intact and retains all
its tension.
6.10 Assembling the throttle lockout,
throttle and spring
1
Refi t throttle F and spring G and knock in pin E.
Insert the throttle actuator rod D into the hole in
throttle F. Fit the throttle lockout C. Hook spring G
into the throttle lockout.
24
- English
Fig 31
Fig 32
Fig 33