Assembling The Throttle Lock, Throttle Control And Spring - Husqvarna Jonsered CS 2245 Workshop Manual

7
Now loosen the spring.
Cleaning and inspection
• Clean and inspect all parts carefully. If there are
any cracks or other defects replace the dama-
ged parts with new ones. Always use original
parts.
• Check that the spring is not broken and has not
lost its tension.
6.10 Throttle lock, throttle trigger and
return spring – refi tting
1
Lubricate all pins and mating surfaces with a light
oil.
2
Fit the throttle cable (A), throttle control (B) and
spring (C). (see fi gure 22)
3
Hold the spring and insert the throttle lock into the
cut-out in the handle. (see fi gure 23)
4
Check that the throttle cable casing is in the right
position in the petrol tank. Press in the casing until
it stops. (see fi gure 24)
5
Fit the throttle control pin (E) with the help of a
punch. (see fi gure 23)
6
Fit the throttle lock (D) by pressing it onto the shaft
in the handle. (see fi gure 25)
7
Assemble the handle insert using a screw, when
the throttle control, lever, throttle cable and throttle
control lock with pin are fi tted correctly. (see fi gure
25)
A
D
Fig 21
Fig 22
Fig 23
Fig 24
D
Fig 25
Safety equipment
C
B
E
23
English –