Mitsubishi Electric FR-E8AXY E KIT Instruction Manual page 36

NOTE
• Switching between the speed control and the torque control is always enabled regardless of the motor status: in a stop, in
running, or in DC injection brake (during pre-excitation).
• During operation, the control mode is switched between speed control and position control when the output frequency
reaches Pr.865 Low speed detection or lower with no position command given. Switching is disabled when either of the
following signals is ON: Sudden stop (X87) signal (normally open input), Forward stroke end (LSP) signal (normally open
input), or Reverse stroke end (LSN) signal (normally open input).
• Changing the terminal assignment using Pr.178 to Pr.189, or Pr.525 to Pr.531 (Input terminal function selection) may
affect the other functions. Set parameters after confirming the function of each terminal.
CONTROL CIRCUIT INPUT SIGNAL
3
35