Mitsubishi Electric FR-E8AXY E KIT Instruction Manual page 13

 For the FR-E820-0175(3.7K) or lower, FR-E840-0170(7.5K) or lower, and FR-E860-0120(7.5K) or lower
1.
Remove the inverter front cover. (Refer to the FR-E800 Instruction Manual (Connection) for instructions to remove the
cover.)
2.
Use a nipper or the like to cut off the bottom of the front cover for plug-in option.
2. Front cover for plug-in option
3.
Fit the L-shaped spacer, straight spacer, and junction connector to the plug-in option as shown in the figure on the
13. Fit the junction connector to the guide of the connector of the plug-in option, and insert the junction connector as far
as it goes. Fit the L-shaped spacer to the plug-in option so that the lower edge of the option placed on the ridge of the
spacer.
4.
Remove the body screws of the inverter, then install the hexagon spacers to the inverter (tightening torque 0.56 to 0.75
N·m).
12
INSTALLATION
Ensure no burr is left.
page