Advertisement
Battery status display
This setting is saved on the transmitter, independent of the
stethoset receiver you are using.
To change the battery status display:
b
Make sure that the protected settings mode is activated
(see page 36).
b
Press the Balance button L.
Status and display of
the Battery LED
permanently activated
(operation and
charging)*
st
1
LED segment lit
activated for
30 seconds (operation
and charging)
st
1
LED segment off
b
Save the setting by disconnecting the transmitter from the
power supply system (see page 36).
Charging reminder function
This setting is saved on the transmitter, independent of the
stethoset receiver you are using.
To activate or deactivate the function:
b
Make sure that the protected settings mode is activated
(see page 36).
b
Press the Balance button R.
Status and display of
the charging reminder
function
activated*
th
5
LED segment lit
deactivated
th
5
LED segment off
Using additional functions
Function/behavior
The current charge status is
permanently displayed during
charging.
The remaining charge status is
permanently displayed during
operation.
The current charge status is
displayed for 30 seconds during
charging. Then all LEDs go off. The
charging process is continued.
The remaining charge status is
displayed for 30 seconds during
operation. The battery status
display then goes off.
* factory default setting
Function/behavior
When you switch the stethoset
receiver off and the transmitter
switches to standby mode, the
battery status display will flash for
10 minutes to remind you to charge
the stethoset receiver
After switching the wireless
headphone system off, all LEDs
remain off.
* factory default setting
Set 880 | 37
Advertisement
