Advertisement
1...4
Using additional functions
The following additional functions are not required for normal
use of the wireless headphone system. You can, however,
extend the potential use of the system and adjust some of the
functions to your individual needs.
Pairing one or several stethoset receivers with
the transmitter
The stethoset receiver and the transmitter of your wireless
headphone system are factory pre-paired. The following steps
are only necessary if you want to pair additional stethoset
receivers with the transmitter.
You can simultaneously use up to 4 paired stethoset receivers
with your transmitter. All other paired and switched-on receiv-
ers cannot connect to the transmitter.
If more than one stethoset receiver is connected to the
transmitter, the remaining operating time/charge status
and the hearing profile cannot be displayed. In addition,
the balance and a hearing profile cannot be adjusted.
These functions can only be used/adjusted when only
one stethoset receiver is connected to the transmitter.
Option A (contact pairing)
b
Place the stethoset receiver into the transmitter's charging
compartment.
The stethoset receiver is paired with the transmitter.
Option B (proximity pairing)
1
Place the stethoset receiver as close as possible to the trans-
mitter.
2
Switch the stethoset receiver on by pulling the ear bows
apart.
3
Simultaneously press and hold the volume buttons +/-.
Once pairing is completed, the
the transmitter flashes white. Release the buttons.
Using additional functions
Transmitter status
LED on
Set 880 | 33
Advertisement
