Table of Contents
Advertisement
Option
Description
[[Sailing only]]
Select Fixed Angles or Polar laylines.
[Sail
performance:]
[[Sailing only]]
Set the angle of upwind layline calculations.
[[Fixed Angles
only]]
[Upwind angle:]
[[Sailing only]]
Set the angle of downwind layline calculations.
[[Fixed Angles
only]]
[Downwind
angle:]
[[Sailing only]]
Select the Polar table that will define your layline
[[Polar only]]
calculation.
[Polar:]
[Min safe
Enter your vessel's maximum unladen height from
height:]
the waterline. To ensure adequate clearance, it is
recommended that you add a safety margin to this figure
to allow for variation caused by vessel movements.
[Min safe width:] Enter your vessel's maximum width at its widest point.
To ensure adequate clearance on both sides, it is
recommended that you add a safety margin for port and
starboard to this figure to allow for variation caused by
vessel movements.
[Min safe
Enter your vessel's maximum depth when fully laden.
depth:]
This is the depth from the waterline to the lowest point
on the vessel's keel. To ensure adequate clearance, it is
recommended that you add a safety margin to this figure
to allow for variation caused by vessel movements.
[Boat length:]
Enter your vessel's length from bow to stern. Boat length
is used for Anchor mode and the Anchor drag alarm in
the Chart app.
[Bow to GPS:]
Enter the distance that your GNSS (GPS) receiver is from
your vessel's bow. This measurements is used in Anchor
mode and the Anchor drag alarm in the Chart app.
Homescreen
Option
Description
[Num of
Select the number of engines on your vessel. When
engines:]
connected to a compatible system, your MFD can
monitor engine data.
[Identify
Once you have selected the number of engines, select
engines:]
[Identify engines] and follow the onscreen instructions to
configure your engines. May require an extra hardware
interface to enable engine data to be displayed.
[Engine
To interface with [Yamaha] , [Yamaha HDMI] and
manufacturer:]
[Mercury] gateways select the relevant manufacturer
from the list. Otherwise select [Other].
[[Num of
Select whether your MFD is displaying for a twin engine
engines 2 only]]
system, or for the port or starboard side of a quad engine
[Configure
system.
Yamaha Quad
display:]
[Num of
Configures detected batteries.
batteries:]
[Num of
Configures detected generators.
generators:]
[Tanks:]
Calibrate your vessel's tanks.
[Num of interior
Allows the display of multiple instances of interior
environment
temperature and humidity sensor's data. Up to 10
sensors:]
sensors can be used.
Battery configuration
The MFD will automatically detect the number of batteries in your system
when the information is transmitted using standard NMEA 2000 PGNs
127506 & 127508, or via other supported systems. Detected batteries can be
viewed and customized from the battery configuration table.
The battery configuration table can be accessed from the [Boat details]
settings menu: [Homescreen > Settings > Boat details > Configure batteries].
97
Advertisement
Table of Contents
Troubleshooting
