Anchor Mode Settings Menus - Raymarine LIGHTHOUSE 4 Operation Instructions Manual

5. Based on the initial Max swing radius shown in the live view pane, ensure
the location is suitable and that no obstacle could come into contact with
your vessel as it drifts.
6. Head your vessel into the wind/tide.
7. If required, manually adjust the chain length using the [Plus] and [Minus]
buttons.
By default the chain length is 4 times the water depth.
8. Lower your vessel's anchor.
9. Once the anchor hits the bottom select [Mark anchor position].
10. Layout you remaining chain length while reversing / drifting with the
wind/tide.
11. Select [Chain out].
The anchoring wizard page 2 is displayed:
218
12. Check that the anchor is secure. If conditions have changed adjust the
chain length or re-lay the anchor as appropriate.
13. Select [Done (Alarm on)].
14. The Anchor drag alarm will be triggered if the vessel's antenna drifts
outside of the specified Drag limit.
Once the Anchor drag alarm is active it can be cancelled at anytime by
selecting [Cancel – raise anchor] from the Chart app screen or Raise anchor
from the Alarms manager: [Homescreen > Alarms > Settings > Anchor Drag
> Raise anchor].

14.4 Anchor mode settings menus

The following settings menus are available in anchor mode:
• [Cartography] — For details refer to:
• [Layers] — For details refer to:
• [Depth] — For details refer to:
• [View & Motion] — For details refer to:
p.206 — View & motion settings menu
• [Advanced] — For details refer to:
• [Page settings] — For details refer to:
p.201 — Cartography settings menu
p.201 — Layers settings menu
p.204 — Depth settings menu
p.207 — Advanced settings menu
p.209 — Page settings menu