Raymarine LIGHTHOUSE 4 Operation Instructions Manual page 382

ClearCruise™ tab (Object Detection) / (Video Analytics)
Settings (ClearCruise™ tab — Object Detection /
Video Analytics)
[Highlight detected objects]
Uses proprietary ClearCruise™ technology to
highlight and track objects detected in the water.
[Beep on detection]
When enabled, the MFD will audibly beep when an
object is detected.
[Display estimated range]
When enabled, the MFD will display an estimated
range for highlighted objects (objects must be
closer than 300 ft).
[Detection threshold]
Enables you to change the object detection
sensitivity.
Camera motion tab
Settings
[Camera height above the waterline]
To ensure correct alignment of the camera for
tracking purposes the height the camera has been
installed at, above the waterline, must be set.
[Set forward position]
Adjust the Forward position of your camera
[Man overboard]
Enables and disables automatic tracking of a MOB
alarm.
The most recent target is tracked.
382
Settings
Options
[Dangerous AIS targets]
Enables and disables automatic tracking of
• Disable
Dangerous AIS targets.
• Enable
The most recent target is tracked.
[Dangerous MARPA targets]
• Disable
Enables and disables automatic tracking of
• Enable
Dangerous Radar targets.
The most recent target is tracked.
• Disable
[Vertical stabilization]
• Enable
Minimizes the effects of vessel pitch (while used in
a forward or reverse facing position) and vessel roll
(while used in a port or starboard facing position).
• 1 to 16
[Horizontal stabilization]
Minimizes the effects of vessel pitch (while used in
a forward or reverse facing position) and vessel roll
(while used in a port or starboard facing position).
*Horizontal stabilization is intended to keep the
camera pointed in a fixed heading, even as the
Options
vessel turns.
• 0ft to 99ft
Note:
Horizontal stabilization is not a form of target
tracking. It is best used to reduce the effects
Displays the forward of subtle heading changes when running in a
alignment picture fixed direction. Whenever the vessel makes a
notable course change, the camera will need
• Disable
to be manually adjusted to align with the new
heading
• Enable
[Enable scan]
Enables and disables Surveillance mode.
Surveillance mode pans the camera left to right
continuously to the specified speed
Options
• Disable
• Enable
• Disable
• Enable
• Disable
• Enable
• Disable
• Enable
• Disable
• Enable