Table of Contents
Advertisement
Troll mode
24.6 Settings
The settings page can be used to view fault codes, schedule maintenance,
and calibrate your engine(s).
Fault codes
The fault codes tab displays all live engine faults detected on the network.
Note:
• The fault codes tab default setting is to display fault codes from all
engines.
• You can use the filter option to display fault codes for a specific engine
and hide codes for all other engines.
Yamaha app
If your engine supports Troll mode it can
be enabled from the engine page. Troll
mode is enabled by pressing the Troll mode
toggle or by selecting it from the menu.
Note:
• Lower engine RPM and go into idle
mode before attempting to activate
Troll mode.
• When Troll mode is enabled your RPM
gauge will change from x100 r/min to
r/min, allowing for more precise control.
Maintenance
The Maintenance tab displays the amount of time since your Yamaha
engine(s) have been serviced.
The amount of hours since last service will automatically accumulate when
your Yamaha engine(s) are running. When your engine(s) have been serviced
you can long hold the row and select [Reset] from the pop up to return the
amount of hours back to 0.
Note:
• A default interval of 100 hours is displayed at the top, this is the
recommended maximum amount of time you can use your engine(s)
before a service is required.
• Additional user configurable intervals can be customized by long holding
each row and choosing the interval length.
Advanced
The Advanced tab is used during the installation and calibration of your
Yamaha engine(s). For more information on how to install and calibrate your
Yamaha engine(s) refer to Yamaha engine installation manual or Yamaha
dealer.
[Options:]
[Gateway reset] — System protocol information reset.
[Engine instances reset] — Engine instances reset. Engine(s) will be
reordered based on engine position:
371
Advertisement
Table of Contents
Troubleshooting
