Table of Contents
Advertisement
Menu item and description
[Marine protected areas]
Allows clear identification of areas where commercial
and recreational fishing is prohibited or restricted.
This setting is available when using C-MAP® charts.
[Fishing AOI]
Enables and disables the display of Fishing AOIs (Areas
Of Interest).
This setting is available when using LightHouse™ and
C-MAP® charts.
[ActiveCaptain]
Enables and disables the display of crowd-sourced data.
This setting is available when using C-MAP® charts.
Related topics:
•
p.211 — Navigate mode settings menus
•
p.214 — Fishing chart mode settings menus
•
p.218 — Anchor mode settings menus
•
p.228 — Racing mode settings menus
Depth settings menu
The depth settings menu contains depth contour related settings.
Menu item and description
[Show soundings]
Enables and disables the display of depth soundings on
the chart. When set to [Manual], depth soundings will be
shown from [Zero to] the maximum depth you specify.
This setting is not available for Raster charts
[Show contours]
Enables and disables the display of depth contours on
the chart. When set to Manual, contours will be shown
from zero to the maximum depth you specify.
This setting is available when using LightHouse™,
C-MAP® and Navionics® vector charts.
204
Options
Menu item and description
• On
[Shallow contour]
Determines the depth at which the Shallow contour is
• Off
displayed. The Shallow contour cannot be set to a value
greater than the Safe contour or Deep contour value.
This setting is available when using LightHouse™, legacy
• On
LightHouse™ and S-63 vector charts.
• Off
[Safe contour]
Determines the depth at which the Safe contour is
displayed.
The Safe contour cannot be set to a value that is less
• On
than the Shallow contour or greater than the Deep
• Off
contour.
This setting is available when using LightHouse™, legacy
LightHouse™ and S-63 vectors charts.
[Shallow area]
Enables and disables identification of areas deemed
to be shallow. When enabled, a red hatched area is
displayed in areas shallower than the depth specified
in the [Zero to] field.
This setting is available when using Navionics® charts.
[Deep contour:]
Determines the depth at which the deep contour is
shown. E.g. if you set this to a value of 30 meters,
any water with a depth greater than 30 meters will be
displayed as a deep contour.
This setting is not available for Raster charts.
Options
[Depth gradient]
• None
Allows you to specify the gradient shade between
shallow and deep.
• Manual
This setting is available when using LightHouse™ and
• All
legacy LightHouse™ vector charts.
[Deep water color]
• None
Allows you to specify the color that will be used to
display Deep water.
• Manual
This setting is available when using C-MAP® and
• All
Navionics® charts.
Options
Numeric depth
value
Numeric depth
value
• On
• Off
Numeric depth
value
• Dark to light
• Light to dark
• White
• Blue
Advertisement
Table of Contents
Troubleshooting
