Mounting An Automatic Gun; Mounting To A Rod; Mounting To A Stationary Support Robotic Arm; Connecting Airline And Accessories - Graco FUSION 248597 Instructions-Parts List Manual

Mounting an Automatic Gun

Mounting to a rod

1.
To mount the gun on a 1/2 in. diameter rod, insert
the bar (A) through the hole in the gun body as
shown.
2.
Secure the gun to the bar by tightening 1/4 in. - 20
mounting screws.

Connecting Airline and Accessories

1.
On the gun air supply line, install an air pressure
regulator.
• A minimum of 80 psi (0.55 MPA, 5.5 bar) air
pressure must be supplied to the gun for proper
operation.
• A four-way air valve, which exhausts cylinder air
in both directions, is required.
2.
On the gun air supply line, install a bleed-type air
shutoff valve downstream of the gun air regulator.
310648E
Mounting to a stationary
support robotic arm
To mount gun to stationary support or robot arm, see
mounting hole dimensions, page 54.
Clean off air
Two .128 in.
alignment
pin holes
Three 1/8 in. -
27 npt ports
(air inlet)
3.
On the main air line, install a bleed-type air shutoff
valve.
Clean off air
Two 0.128 in.
allignment pin
holes
Three 1/8 npt
ports (air
inlet)
Mounting an Automatic Gun
Gun
actuation
Two 1/4 -
20 unc
holes
Gun
deactuation
ti4751a
Gun
actuation
Two 1/4 -
20 unc
holes
Gun
deactuation
ti4751a
11