Table of Contents
Advertisement
Piston and Purge Rod
Spacer (61) is optional. For more forward travel of
piston, remove spacer. Using spacer (61) elimi-
nates "spitting" when gun is closed. Removing
spacer (61) allows purge rod to travel further for
more efficient purging.
1.
Follow Pressure Relief Procedure, page 18.
2.
Flush Gun, page 23.
3.
Disconnect air (D) and remove fluid manifold (G).
G
4.
Disassemble Front End, page 30.
5.
Unscrew purge rod stop (15) to remove piston
safety lock assembly. Inspect o-rings (14, 18) in
place.
18
310648E
6.
7.
D
TI4968a
8.
15
14
TI3847a
Pull purge rod to remove piston (32). Inspect pis-
ton o-ring (16) and shaft o-ring (19).
32
Inspect purge rod (31) for scratches or damage.
Unscrew rod from piston with nut driver. Inspect
o-ring (18). Liberally lubricate with Fusion Gun
Lubricant. To reassemble, thread purge rod (31)
into piston (32) until rod stops. Spacer (62) acts as
a positive stop.
31
32
19
61
Liberally lubricate piston o-rings. Install spacer (61)
onto piston assembly. Reinstall piston. Shaft is
keyed for proper assembly. Push firmly to seat pis-
ton. Rotate piston/purge rod assembly clockwise
with nut driver until piston is fully seated.
Repair
16
19
TI4988a
62
18
16
TI3848a
TI4988a
39
Advertisement
Table of Contents
